Fixed Reaver Pro Fails to Flash Firmware When Updating

Discussion in 'Xiaopan Support' started by SINBAZO, 8 Nov 2014.

  1. SINBAZO

    SINBAZO Member

    Joined:
    5 Jun 2014
    Messages:
    1
    Likes Received:
    0
    hello, i have a Reaver Pro and was very excited about updating the Firmware today. I Downloaded the bin file. i watched the "upgrading your firmware video", and followed those directions :
    go to configure
    click update firmware
    find the file
    i get a %100 upload
    then the "flash firmware" firmware button appears
    I click it and get the two warning screens (clicking ok on both)
    after 3 min the screen refreshes BUT my firmware listed is the same old firmware version and all of my Attack info is still shown. what am i doing wrong?
    also, quick stupid question, is there a way I can save my attack info then reinstall it so the new firmware dosent wipe out 2 months of attack info?
    --- Double Post Merged, 8 Nov 2014 ---
    ok, my bad. i just found the infor on the 2 step firmware upgrade. still could use help backing up the attack data before i flash the firmware
     

Share This Page

Loading...