Full tutorial with pictures attached. Credit goes to comfortsurf.com and firstname.lastname@example.org 1. Insert CD to you CD Rom, restart your computer and boot the CD Rom (just like when you format computer to install windows, boot the CD). You may need to change your boot order to CDROM first instead of Harddisk. It normally change change in bios setup during you start computer by press F2, F10, ESC depending your computer. ** If you don't know how to do this, kindly consult your friend/computer technician with basic computer knowledge. Or go to www.google.com and search for how to "boot from CD ROM drive". 2. After boot successful, you will be bring to below screen. Click the Minidwep-gtk to start the program. 3. When below windows prompt out, just click ok. 4. Click the Minipwep-gtk to start the program. Then click scan to scan the available wireless. 5. Select the wireless with client, and click the launch to start cracking process. Note: the router that you want to hack must be using (have data transfer), the higher data transfer, the faster the cracking process. If you notice that IVS value is not running, or running very very slow after few minutes, it means that there is no data transfer on the router. You may look for other time (when the router is using) to test again. 6. Below showing the IVS is running and increasing... Normally IVS Reach value around 30000 to 50000, the password will be found. 7. Below shown successful case with password shown. Copy down the password and close the software. Then logout and shutdown the machine. For WPA/WPA2: 1. Just select WPA/WPA2 and click scan. 2. Select the wifi that have client and click the dictionary attack to browse to your dictionary password list. 3. Click lauch to attack. If password still not found after the run out the dictionary list, you have to prepare a bigger dictionary list.